I have just started on rfactor again after two years. Last time I ran version 2.0 with the old cup car. I always did practice laps at nurburgring. I tryed running laps here in the cot and the car doesn't turn in the higher speed corners (turn 10). Lower speed corners feel normal. I noticed that even turning the wheel at speed down a straigntaway the car is not responsive to that input. Replays show I am getting input to the front tires which makes me think that it is car setup based (but maybe not). I don't have a cot setup for nurburgring. Honestly I don't even know where to start. I have a big rear sway bar, a 5.5 in ride height, 30deg of steering and leave everything else untouched. Any thoughts would be appreciated, and let me know if you need more info about settings or anything else.
Thanks

Do you have the Road course chassis loaded?
Do you have the road course tires loaded?

Just a couple thoughts.

I turned an 8:17.036 lap on The Mother version of the old Nürburgring with the attached set up. This was with the 3.0 or so version of the TPSCC mod.

_________________
"You need to believe in things that aren't true. How else can they become?"-- Death, Hogfather

"And now there remains only one final question. Have you been naughty or nice?"-- Death, Hogfather

Chassis and tires are set to road course. I will give that setup a try, see what it feels like and let you know how it works for me.
thanks

Your setup is night and day better than what I was using. I also found out that my speed sensitivity was causing the lazy response at high speed. I had the slider set to 100 when it should be closer to 0. I think I have made this mistake before. Thanks again for the setup